Inductive Cutting Stone Saw Blade

Generally speaking, the working conditions of granite saw blades are relatively poor. Its main purpose is to cut stone saw blades. Widely used in marble and granite cutting. It is an important tool in stone industry.
1. See idling: especially when the new matrix is idle for about 10-20 minutes for the first time, it also needs to idle with water in the high temperature season in summer. Its purpose is to eliminate the influence matrix of the welding joint, improve the internal quality of the blade and maintain the high-speed rotation of the memory.
2. The cutting block shall not be less than 0.5 cubic meters, and the bottom pad shall be placed securely with solid wood and firmly inserted. The block shall be symmetrically located on the work table to ensure that the work cart is stable, jittery and jittery.
3. Adjust the switch block according to the length, width and height, so that the lifting of saw blade and the range of vehicle travel are effective. The saw blade should be left at 10-20mm of the block. After sawing, the cutting block from the bottom should be 20 40 mm. Before the operation of the blade, all the saw joints should be pulled out of the block at a distance of not less than 150 200 mm to prevent
Blade impact block.
4. For the cutting of the saw blade before the idling stability test, the edge of the saw blade starts to contact with the block, and the cutting saw blade rotation is not allowed to stop, but can be stopped after exiting the cut.
5. If any stone is found in the cutting block, stop cutting immediately, fix it before the fixed block, and continue to work and cut. Do not move the block arbitrarily.
6. When cutting the knife, obvious deceleration or even knife clamping phenomenon is found, which may be caused by slipping belt, loose or too deep pressing nut, and too fast cutting speed. It should be adjusted in time.
7. Linear speed should be the adaptation of hardness and wear resistance to the processing of stone, because the hardness of various granite will also be different. If a single stone is soft, tell its supplier to see the type of stone you cut, and ask them to provide corresponding local resistance grinding. On the contrary, if it is difficult to cut sharp granite type. If all kinds of stones are cut, the corresponding universal saw blade (prompt: the online speed is not high, improve the sawing efficiency and reduce the service life of the saw blade)
8. The feed rate and performance mainly depend on the processing of the material. The feed rate and cutting depth of each material are within a certain range. If the speed is too high, it will accelerate the wear and fall off of the diamond saw blade, which is caused by excessive consumption. If the speed is too low, it will make the blade self-grinding process can not be carried out normally, "dull, slipping and loss of cutting ability. Generally, the feed rate is slow, and the sawing should be uniform.
9. For stone materials such as marble with medium hardness, limestone can pass through hard stone, and large grinding granite, sandstone should be cut in steps. The cutting depth of granite should be 10 20 mm with a single saw, 50~100 mm with a marble cutting depth, and 3 mm with two or more pieces of hard granite cut on both sides. The hardness of stone depends on the performance of saw and saw.
10. The rotation direction and feed direction of the blade are cut along the same stone, while reverse cutting, cutting, an upward vertical force, forms the potential of a stone. Therefore, for hard stone, cutting should be used under the same conditions. When reverse cutting is adopted, the cutting depth is reduced, generally to 1/3 - 1/2 cutting.